Purpose of the Repair ECU course:
• How to test and repair power Supply for sensor inside ECU?
• How to test and repair Sensor signal inside ECU?
• How to test and repair Actuator inside ECU?
• How to test and repair Can Bus inside ECU?
Procedure to test ECU BOSCH EDC16.(When you buy equipment we will send you documents and videos.)
Test Injector and Fuel metering unit
You must connect ecu with: Injector, Fuel metering unit, Rail pressure sensor (RPS). CKP,CMP
Step1: Connect ECU/PCM to power supply 12V:
Step1: Connect ECU/PCM to power ground:
Step 2:Connect Scan tool to Data Link Connector (DLC)
Step 3: Connect CKP/CMP SIGNAL
You should refer to the following link for more information:
- http://www.quocdungmortors.com/2020/01/11/how-to-use-ecu-tester-tool/ (hướng dẫn sử dụng thiết bị)
- http://www.quocdungmortors.com/2020/01/16/procedure-to-test-ecu-with-ecu-tester/ (quy trình kiểm tra hộp số Hyundai/Kia)
- http://www.quocdungmortors.com/2020/01/09/procedure-test-and-repair-ecu-hyundaikefico-7-9-8/ ( Kiểm tra ECU Hyundai/Kia)
If you have question or need any support, please do not hesitate to contact us.
With best regards
Tel : 0932 798 050 – 0906935484
Fb : https://www.facebook.com/ECU-Pro-267467560675669/
Mail : firstname.lastname@example.org
Zalo : 0932798050